RIFF Box License Activation Available

Great news for all owners of unauthorized RIFF Box hardware !
We just decided to offer License Activation, which will enable all unauthorized users to use full set of original RIFF Box features !

With this activation You can:

  •  Register RIFF Box and receive license file;
  •  Update RIFF Box Firmware;
  •  Repair “RTCK Signal Does not respond”;
  •  Access RIFF files download servers;
  •  Receive support on RIFF forums;
  •  Receive and use all future updates;

This service is available trough Mr Softmobile, well known and trustable person in GSM world.
Please visit www.softmobile.net  to order License Activation Server credits.
This service is mainly intended for dealers with 10+ quantity of unauthorized RIFF Box hardware.
If You’re end user with just one box, please contact nearest authorized RIFF Box dealer for details.

RIFF JTAG – Samsung Star Duos (C6712) Unbrick – Boot repair supported

29.11.2011  Samsung Star Duos (C6712) Unbrick – Boot repair supported

Samsung C6712 resurrection is simple. Battery is not required. To power the board it’s most convenient to use an USB Data Cable.
In order to contact to JTAG pads you may need to carefully scratch off paint covering (mask layer) above them. Sometimes there is reset problem with these phones, thus you may need to disconnect and then connect USB cable again.

To resurrect Samsung C6712 do this:

  •  Solder JTAG cable to Samsung C6712 JTAG pads;
  •  Insert battery and connect USB cable to phone and PC;
  •  Make sure Samsung C6712 is selected in the list of models
  •  Click Resurrect button;
  •  Wait few seconds until software signals a successful operation completion;
  •  Disconnect USB cable, de-solder JTAG wires;

Now phone is in bootable condition, that is, even if it does not start up normally, you can flash it using original Samsung downloader software to restore it to the working state.

To enter download mode:

  •  Disconnect PC cable;
  •  Insert battery;
  •  Hold both ‘Volume Down’ and ‘SIM Swap’ keys and press Power-On.
__

RIFF JTAG – Samsung Corby II – S3850 supported

24.10.2011  Samsung Corby II – S3850 supported

Samsung S3850 resurrection is simple. Battery is not required. To power the board it’s most convenient to use an USB Data Cable.
In orger to contact to JTAG pads you may need to carefully scratch off paint covering (mask layer) above them.

To resurrect Samsung S3850 do this:

  •  Solder JTAG cable to Samsung S3850 JTAG pads;
  •  Insert battery and connect USB cable to phone and PC;
  •  Make sure Samsung S3850 is selected in the list of models
  •  Click Resurrect button;
  •  Wait few seconds until software signals a successful operation completion;
  •  Disconnect USB cable, de-solder JTAG wires;

Now phone is in bootable condition, that is, even if it does not start up normally, you can flash it using original Samsung downloader software to restore it to the working state.

To enter download mode:

  •  Disconnect PC cable;
  •  Insert battery;
  •  Hold both ‘Volume Up’ and ‘Call’ keys and press Power-On.